Ducati Monster Motorcycle Forum banner
1 - 1 of 3 Posts

· Registered
15,140 Posts
The squeak is more likely coming from the heim joints on the hoop, or the linkage. There are needle fittings on the heim joints. The rest needs to be disassembled to be lubed.

The swingarm has needle bearings in the engine case. It is not a difficult job. If you pull the pivot pin make sure to take note of which shims went where.
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.