Ducati Monster Motorcycle Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
735 Posts
Discussion Starter · #1 ·
What is the easiest way to adjust the rear suspension tie rod? I tried to figure out the best way to sneak a 19mm wrench in there and it is impossible. From what I can see removing the top SHCS then wrenching out the bar ends, then retightening the lock nuts would be easiest. Are there going to be any issues getting that bolt lined back up? Any suggestions.
 

·
Registered
Joined
·
735 Posts
Discussion Starter · #3 ·
I just wanted to make sure I wasn't missing anything. I think if you just pull the top SHCS, rotate the bar back, you should be able to loosen and adjust the bottom w/o removing it. Then proceed w/ the top mount. We'll see how it goes. I hope I can borrow a rear tire stand.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top