Rotating banjo's on mc's

533 Views 3 Replies 3 Participants Last post by goldenchild, Nov 7, 2006

goldenchild

Discussion Starter · Nov 7, 2006

Let's say I needed to rotate the banjo bolt on my mc's. If I just loosen up the nut that holds them in place just enough to be able to rotate the banjos, do I have to worry about rebleeding if no fluid leaks out? Will the crush wahers be ok? Thanks.

Save

1 - 4 of 4 Posts

Desmo Elmer

· #2 · Nov 7, 2006

I've loosened and rotated the banjos on both clutch and brake master cyl. a few times without having to bleed, and the crush washers were fine...

You will likely get a little brake fluid oozing out so be ready with a rag.

YMMV