Ducati Monster Motorcycle Forum banner
1 - 5 of 5 Posts

·
Banned
Joined
·
303 Posts
Discussion Starter · #1 ·
I am working on a custom exhaust system involving some R1 cans. I my attempts to make it look just right, I need some new sleeves and was thinking about using some duc sleeves in good condition. That is, if they fit. So if anyone out there is a little bored and wants to measure the height, width, and circumference of their stock cans, it would be very apprecitated.

ps. the length isn't neccesary seeing as I would be cutting them shorter.
 

·
Premium Member
Joined
·
2,089 Posts
The stock DSS cans are oval, not round, so I seriously doubt they'll fit over R1 cans.

Justin
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top