Ducati Monster Motorcycle Forum banner
1 - 3 of 3 Posts

·
Registered
2013 Monster 796 ABS
Joined
·
4 Posts
Discussion Starter · #1 ·
Hello Monster-knowledgeable folks-

Short version: My M796 ABS seems to have an oil leak coming from a bolt head directly behind the body of the starter motor. Looking at the shop manual and parts diagram, it shows a grub screw ("dowel" in the parts diagram), a gasket, and a bolt over the top, but doesn't say what it is for.

Is it feasible that this is the source of my leak? Searching this and other boards has not found other people with this same issue, so I'm a bit dubious. What is this thing, and do I have to pull the case apart and remove the starter to get at it?

Automotive fuel system Light Motor vehicle Fluid Hood
Automotive lighting Automotive tire Motor vehicle Yellow Rim


Longer version:

I picked up my 2013 Monster 796 ABS last summer, and it had a small oil leak. A visible drop of oil hanging from the bottom of the oil filter after a long ride, but no measurable oil loss.

It was looked at by a dealer, and they said it was coming from the oil filter which was too loose. They tightened it to spec and said problem solved. But when I got it home and ran it, it was still leaking. Thinking that perhaps I had a bad filter or gasket, I put on a new filter and tightened to spec. Still leaking. So I cleaned the whole bottom of the engine with brake cleaner and then sprayed with baby powder, and it looks like its coming from a bolt head up behind the starter. Photos attached.

Looks like a tough thing to get at, so for the short term, I squirted Permatex all around the bolt head, forming a continuous barrier around the apparent source. Cleaned everything again, and no more leak. Until this summer, when after running hot there's a slight film of oil on the bottom of the motor.

So, what is this thing, have you ever seen a leak here before? I'm all set to drain the oil, pull the cases apart, remove the starter and replace these parts (grub screw, gasket, bolt) to torque, in hopes that will solve the problem, but I'd hate to do all that and then discover that this could not possibly be the source, or that there's an easier fix. Above that point looks clean, but is there a typical leak above I should look more closely at?

Any thoughts?

Thanks in advance! Photos and part diagrams attached.


Sure appreciate any help you can give!


Font Art Auto part Circle Drawing
Product Font Rectangle Plumbing fixture Gas
Black Organism Font Line Urban design

Product Font Screenshot Number Rectangle
 

·
Registered
2013 Monster 796 ABS
Joined
·
4 Posts
Discussion Starter · #4 ·
That's helpful, thanks; I didn't realize I would need a new starter gasket to put it back together.
I have the puller for the alternator cover and some Yamabond.
Shame it's such a lot of work to essentially tighten a bolt.
I would really like to know what that bolt/gasket/dowel is for, though!

c-king
 

·
Registered
2013 Monster 796 ABS
Joined
·
4 Posts
Discussion Starter · #8 ·
From what I've seen I'm expecting a similar access hole for the third starter bolt on the 796. Hopefully I can leave the flywheel alone!
Do I need to pull the plugs in order to rotate the engine to get the access hole to line up?

Thanks!

C-King
 
1 - 3 of 3 Posts
Top