Ducati Monster Motorcycle Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
I was hunting for information on some bar risers and what would work the best, how much slack is in the cables so I know what size to get. I was thinking of the Rox 2" Pivot Risers for 7/8" Handlebars for 821 but not sure if the cables will reach 2"

I think the 1200 and 821 are essentially the same except displacement from what I can tell, but I could be mistaken. Trying to make it a bit more comfy, I'm getting to old to be hunched over all day lol...

Also the is the seat the same, thinking about going Corbin to save my butt
 

·
Registered
Joined
·
285 Posts
I was hunting for information on some bar risers and what would work the best, how much slack is in the cables so I know what size to get. I was thinking of the Rox 2" Pivot Risers for 7/8" Handlebars for 821 but not sure if the cables will reach 2"



I think the 1200 and 821 are essentially the same except displacement from what I can tell, but I could be mistaken. Trying to make it a bit more comfy, I'm getting to old to be hunched over all day lol...



Also the is the seat the same, thinking about going Corbin to save my butt
Keep digging...the 2in riser was covered at some point...I recall it not working out as planned...but it did fit...sorta...and the 1200 bars have a different size at the clamp so they aren't direct replacements and they might be narrower due to the reservoirs being more compact

Sent from my Pixel XL using Tapatalk
 

·
Registered
Joined
·
5 Posts
Discussion Starter #6
Thanks guys I found the CNC risers not sure I want to mess with drilling bars and stuff will see how they do. Anyone know if the seats are the same? Corbin has one for the 1200 but nothing yet specifically calling out the 821. I did 170 miles on it in the mountains this past weekend and while it's amazing in the corners when you just cruising along in traffic (it was busy) it's a bit uncomfortable and I'm getting old lol.
 

·
Registered
Joined
·
285 Posts
Thanks guys I found the CNC risers not sure I want to mess with drilling bars and stuff will see how they do. Anyone know if the seats are the same? Corbin has one for the 1200 but nothing yet specifically calling out the 821. I did 170 miles on it in the mountains this past weekend and while it's amazing in the corners when you just cruising along in traffic (it was busy) it's a bit uncomfortable and I'm getting old lol.
Seats are the same...the model year is more important
 
1 - 7 of 7 Posts
Top