[Guest]

just installed Sil Motor Ti Hi Mounts, they sound great and look awesome. the only problem that i have is the rear brake fluid reservoir. the cap is touching the s-pipe and i'm afraid that it will damage it over time. does anyone have a solution to this problem? PLEASE HELP!! THANKS

 

[Guest]

Did you get spacers with your exhaust to move the rearset assembly out? Mine came with spacers (although I didn't have to use them). If you can mover the rear set out some, you can readjust your s pipe so it's not touching the cap.

Good luck.

 

[rugbymook]

I had to get a longer piece of tubing to run to the master cylinder resevoir. I bolted mine (with a section of strapping) just in front of the crankcase breather on the engine. It is just long enough to be able to switch between the rearsets and stock setup.

 

[Jajje76]

I simply solved the problem by using a longer bolt, and ONE mutter!

See picture below!

/fred the swede!