Ducati Monster Motorcycle Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
829 Posts
Discussion Starter · #1 ·
I just installed new CRG levers on my Monster. Both levers are plain levers. I need to fabricate a tab to operate the clutch electrical switch. How do you adjust the trim screws? I have not seen too much info on this. Ducati Suite recommends screwing the trimmer in until the fluid is not disturbed when squeezing the levers, then opening them one turn. Anybody tried this?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top