|Topic Review (Newest First)|
|03-01-2017 09:16 AM|
If that's the same item, it says it fits...[/QUOTE
Probably. Curious if it will fit becos I may get a good deal on a used one coming from a 696. Rather than spending on a $220 cad on a evotech.
|03-01-2017 09:09 AM|
If that's the same item, it says it fits...
|03-01-2017 09:05 AM|
Originally Posted by Frosty 2.0 View Post
|03-01-2017 09:00 AM|
This I think is the fender eliminator for the 696. look at the bottom side of the tail.
|03-01-2017 08:56 AM|
I'll tell you... all the taillight wiring and such is down in that well, too... so if they eliminate the room for the servo, they would have to route the wiring harness elsewhere. Easy solution would be to make one model for all 3 bikes...
You could always call CW...
|03-01-2017 08:54 AM|
|03-01-2017 08:52 AM|
Thanks for the pics. Am really not sure about the CW because I read somewhere that the CW's bottom seems to be flatter and it the space may not fit the servo.
|03-01-2017 08:51 AM|
The box section seen in the first photo leaves room for the 796 exhaust servo, but is probably just empty room for the 696/1100.
2nd photo... I have a Duc-ee.
Bad key position. I don't pull my seat very often, so I don't really care, but if you hang your helmet a lot, I could see where it would be a pain.
did you use CW fender eliminator on your Evo?
I meant Evotech.
|03-01-2017 08:49 AM|
|03-01-2017 08:43 AM|
|This thread has more than 10 replies. Click here to review the whole thread.|