Please Help Installing Integrated Tail Light
I just purchased an LED integrated tail light (smoke) on eBay. It doesn't come with installation instructions. Electrical re-wiring is not my forte. Could someone please describe to me the proper diagram I should follow to install this unit? Here's a description of the wires I have going into the new unit:
Red, White and Blue + Black (ground) - going into the center of a rubber recepticle leading into the housing of the LED panel, all channeled together in an insulator tube.
Blue into the port side of the recepticle. (I'm guessing left turn signal)
Yellow into the starboard side of the recepticle. (I'm guessing right turn signal)
The stock setup is as follows:
Gr/R (to tail light bulb)
W/G (to W/Gr of the left turn bulb)
Y (to tail light bulb & number plate light)
P/Bk (to W/Bk of the left turn bulb)
Finally, how do I set up the new wiring so that I can connect LED license plate bolts when I reposition the plate? I'm not sure which is the hot wire here, but I'm guessing it's Gr/R?
It's going on an '04 M800i.e.