Ducati Monster Motorcycle Forum banner

Fender Eliminator

4K views 19 replies 3 participants last post by  Frosty 2.0 
#1 ·
Hello, do you think that a Competition Werkes fender eliminator from a 696 will fit and work on a monster 796? Thanks.
 
#10 ·
That's the exhaust servo.... and my thought is the CW will fit anyway, even if it's built to accommodate the servo on the 796. I can take a pic of my Evo if you want to see what it looks like.
 
#13 ·
The box section seen in the first photo leaves room for the 796 exhaust servo, but is probably just empty room for the 696/1100.

2nd photo... I have a Duc-ee.

Bad key position. I don't pull my seat very often, so I don't really care, but if you hang your helmet a lot, I could see where it would be a pain.

did you use CW fender eliminator on your Evo?

I meant Evotech.
 
#16 ·
I'll tell you... all the taillight wiring and such is down in that well, too... so if they eliminate the room for the servo, they would have to route the wiring harness elsewhere. Easy solution would be to make one model for all 3 bikes...

You could always call CW...
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top